m14a2a modem

Solved
nrithya's picture
nrithya
Junior(0)

we are developers working with the AT&T IoT starter kit. We have been trying to find a way to expose low level network and hardware information abot the modem module. We tried to run the AT commands listed by AT+CLAC and were able run a majority of the  standardized(+) commands but were unable to figure out the formats of the modem specific (%) commands. Any support to run these commands would be appreciated. Any other pointers on exposing Low level information beyon dAT commands is also welcome

Thanks in advance!

LightCollector's picture
LightCollector
Moderator(20)

Hi,  You can find the AT command guide further down on this page:  https://marketplace.att.com/quickstart

 

Best regards

nrithya's picture
nrithya
Junior(0)

hey,

i have this guide. Most of the % commands listed by CLAC have no support in this document

LightCollector's picture
LightCollector
Moderator(20)

Hi, I have contacted WNC with your request for more info about the CLAC.  Will update once we hear back.  For whatever reason the forum didn't flag your response as new until today, sorry for the delay.  I would guess it might take another week or so to hear back.

 

Best regards

kevinkeryk's picture
kevinkeryk
Moderator(0)

Hi nrithya,

Upon further investigation, it turns out that the support model in place for this device does not allow us to publish any information publicly beyond the AT Command documentation that is already available from the AT&T Website. I am sorry if this inconveniences you during your development, unfortunately we are limited by the support model that is in place.

That being said, if there are modem specific (%) command that you are seeing available under CLAC that you need access to in order to complete your development work, please let us know which ones and I can help address these through private messaging.

Best Regards,

-Kevin