Can't Join Network

Unsolved
dlukach's picture
dlukach
Junior(0)

Hello Guys,

I was following the getting started guide and ended up all the way to step 33. Of course the exercise did not work so I decided to take a look over serial. After reading the console I found that the board is failing to connect to my wifi even though I'm putting the correct password. Is there any solution to this issue?

Starting WICED v3.4.0-AWS
Platform BCM94343W_AVN initialised
Started ThreadX v5.6
Initialising NetX_Duo v5.7_sp2
Creating Packet pools
WWD SDIO interface initialised
WLAN MAC Address : B0:38:29:43:CC:3D
WLAN Firmware    : wl0: Jun 24 2015 17:47:50 version 7.45.41 (r554772) FWID 01-5eb3f26a
 Please wait, connecting to network...
(To return to SSID console screen, hold USER switch for 5 seconds during RESET to clear DCT configuration)
Joining : CKYY2
Failed to join: CKYY2
Joining : CKYY2
Failed to join: CKYY2
Joining : CKYY2
Failed to join: CKYY2
[MQTT] Connecting to broker 0.0.0.0 ...

 

PeterF's picture
PeterF
Moderator(16)

Daniel

 

Please refer to the Installation Tutorial documents (Part1, Part2) listed at:
http://cloudconnectkits.org/product/avnet-bcm4343w-iot-starter-kit

In addition, I'd also suggest viewing the short videos available at that page...

 

Regards

Peter